Console, Electronic board
This part is NO LONGER AVAILABLE. You cannot purchase this part.
|
|
|
Display console electronic board.
NOTE: The software in these boards is FLASH memory, it requires a special memory upload. If you are not capable of uploading the new software DO NOT order this part. Failure to load the new software will cause this board to not operate.
NOTE: If you order this part and can not get the software loaded we will charge all Bench Testing and Restocking fees.
NOTE NOTE NOTE<>>NOTE NOTE NOTE |
* Images may not be identical to part.
# |
Part Name (Click to view) |
BOM
Qty | 4 | NLA Console, Electronic board | | 6 | Touch Pad, Display, Inductive | | 7 | Wire harness, 8 Pin | | 8 | Wire harness, 8 Pin | | 9 | NLA Lower board | | 16 | NLA Motor, Incline | | 21 | Handlebar, Left | | 21.01 | HANDLEBAR & PIVOT KIT, LEFT, C556I, | | 22 | Handlebar, Right | | 22.01 | Kit, Handlebar & Pivot Right | | 27 | EPROM, 6 phase | | 29 | Inline Modular Jack | | 32 | Heart rate board | | 33 | Heart rate grip (top) | | 34 | Heart rate grip (bottom) | | 35 | Shield, Touch sensor | | 36 | Holder, Water bottle | | 38 | Cover, Lift Front | | 39 | Cover, Rear, Lift | | 40 | CROWN - LIFT COVER | | 42 | DOUBLE ADHESIVE FOAM TAPE 1 X 4X1 | | 44 | Ramp, Lift | | 45 | Pivot, Ramp | | 46 | Yoke, Ramp | | 47 | Arm, Stair, Right | | 48 | Arm, Stair, Left | | 49 | NLA Wheel | | 50 | NLA Pedal | | 56 | Link, Total body | | 58 | Arm, Crank | | 62 | Belt, Drive | | 63 | Pulley, Step-up | | 64 | Belt, Drive | | 65 | Generator | | 69 | Resistor Assembly | | 72 | Battery | | 73 | BRACKET - BATTERY MOUNT - C556I RX | | 75 | ASSEMBLY, DRIVE WELDMENT, C576I | | 76 | NLA Cover, Side, Right | | 77 | Cover, Side, Left | | 78 | Cover, Rear Assembly, Front | | 83 | LABEL, WIRING DIAGRAM, EFX, SELF-PO | | 85 | Backplate, Display, Gray | | 87 | FOOT, FIXED, | | 90 | NLA Cover, Rear, Top | | 95 | Fuse, Slo-Blo | | 101 | Plug, Jack | | 103 | Wheel, Transport | | 105 | Grip, Hand, Front | | 106 | Endcap, Stone Grey | | 107 | Handgrip, Back | | 108 | Screw | | 115 | SCREW,MCH,10-32X3/8,PANHD,PHIL,Black | | 152 | LABEL - ACCESSORY TRAY - EN - C576I | | 154 | ASSY-CBL-FFC-12COND-28AWG-2.2in | | 155 | SCREW,MCH,8-32X3/8,PANHD,PHIL,Black S | | 156 | Screw | | 158 | Screw | | 159 | Wire Harness, HR | | 160 | Tie, Cable | | 161 | SCREW,TCS,#8X3/4,PHIL,Black SHARPERIZ | | 162 | Starwasher Locknut | | 176 | ORing | | 179 | Endcap, Mushroom, Internal | | 180 | NLA Wire harness, HR grip | | 181 | Buttonhead Screw | | 182 | Screw | | 190 | HOLE PLUG- PLASTIC .875 X.13-.18 | | 191 | INSERT - SQUARE - NYLON | | 201 | Screw | | 202 | Washer, Flat | | 203 | Endcap, Ramp, Rear | | 204 | Ramp, Channel | | 205 | T-Nut | | 206 | Screw | | 249 | NUT,HEX,1/4-20,NYLON | | 251 | Insert, Clamp, Cable | | 251.01 | CLAMP - CABLE - BLACK - RELEASABLE ON | | 253 | Label, Side | | 254 | Clip | | 255 | Cover, Rear, bottom | | 256 | Fastener, Christmas Tree | | 277 | Nut | | 278 | Screw | | 279 | Washer | | 282 | Washer | | 286 | PIVOT COVER - INNER - LH | | 287 | PIVOT COVER - OUTER - LH | | 288 | WELDMENT - UPRIGHT - LH - PT | | 289 | Assembly, MAIN PIVOT, LEFT | | 290 | PIVOT COVER - INNER - RH | | 291 | PIVOT COVER - OUTER - RH | | 292 | WELDMENT - UPRIGHT - RH - PT | | 293 | Assembly, MAIN PIVOT, RIGHT | | 294 | SCREW,MCH,8-32X3/8,PANHD,PHIL,Black S | | 295 | SCREW - HEX - GR 5 - 5/16-18X1.25 - ZN | | 296 | Assembly - CBL - 2C - 16 AWG - MINI-FIT/QK | | 297 | Assembly - CBL - 18AWG - FLAG QC CONN - 80 | | 298 | Label, Caution "PINCH POINTS" | | 299 | Tinnerman Clip | | 300 | Cover, Rear Curtain, Left | | 301 | Snap Bushing | | 302 | Cover, Rear Curtain, Right | | 303 | Retainer, Stairarm | | 305 | SCREW, BUTTON HEAD, 1/4-20 X 1.50, | | 306 | Screw | | 307 | Wire harness | | 309 | Spacer, Pivot, 1/2 | | 310 | Washer | | 311 | SCREW, SKHD,10-24 X 1.25,Black SHARPE | | 312 | Screw | | 313 | Boot, Targa, Lower, Left | | 314 | Pin, Clevis | | 315 | Screw | | 316 | Screw | | 317 | Screw | | 318 | SCREW,SKHD,3/8-16X2,ZN (MECH PLATIN | | 318.01 | Screw, 1/2 | | 319 | Boot, Targa, Lower, Right | | 320 | Boot, Targa, Upper, Left | | 321 | Pin, Retainer | | 322 | Cover. Wedge, Rear | | 323 | Boot, Targa, Upper, Right | | 324 | REAR COVER ACCESS | | 325 | NLA Cover, Pedestal, Lift | | 326 | Endcap, Ramp, Front | | 327 | NLA Lift, Pedistal, Rear | | 327.01 | Assembly - LIFT PEDESTAL - REAR | | 328 | Wave washer, Crank arm | | 330 | Cover, Ramp, Center | | 331 | Spacer, Lower Link | | 333 | Screw | | 335 | Screw | | 336 | Nut, Locking | | 336.01 | LOCKNUT,FULL,3/8-16,Black SHARPERIZED | | 337 | Spring, Link Arm | | 339 | Screw | | 340 | Screw | | 351 | Insert, Clamp, Cable | | 353 | Screw | | 355 | Bracket, Tensioner | | 356 | Tab, Locking | | 357 | Screw | | 358 | Starwasher Locknut | | 359 | Screw | | 362 | Washer, Flat | | 363 | Shield, Front | | 364 | Shield, Rear | | 366 | Screw | | 367 | CABLE CLIP, DIE COMPANY | | 369 | Clip | | 371 | Washer | | 461 | Screw | | 462 | Clamp, Cable, Vinyl Coated | | 464 | Nut, Hex | | 465 | Wire harness | | 500 | Frame, Repair Kit | | 501 | NLA Endcap, Round, Internal | | 503 | Bushing, Shaft, Link | | 504 | Washer | | 505 | Screw | | 901 | KIT, HARDWARE, C576I | | 902 | Wrench, Allen, 1/4" | | 904 | Wrench, Allen, 3/16" | | 905 | NLA Endcap, Round, Internal | | 906 | Endcap, Handlebar | | 907 | Washer | | 908 | Bushing, Shaft, Link | | 909 | Screw | | 910 | SCREW,SKHD,5/16-18X0.75,ZN (MECH PL | | 911 | SCREW, SELF TAPPING,#8 X 1.50, PHIL | | 912 | SCREW,BTHD,5/16-18X1, ZN (MECH PLAT | | 913 | Washer | | 914 | NLA Cover, Pivot, Left | | 915 | Cover, Pivot, Right | | 917 | Washer | | 999 | LITERATURE KIT - C576I | | |
|
